alpines
[Top] [All Lists]

RE: Replacing Rocker Arms

To: <Jay_Laifman@countrywide.com>, <alpines@autox.team.net>
Subject: RE: Replacing Rocker Arms
From: "Jarrid Gross" <jgross@econolite.com>
Date: Tue, 26 Aug 2003 08:21:28 -0700
Jay,

Ive had great luck with used rockers.
look for ones that are not gooved too much at the tips.
Also look for a new rocker shaft if you can, they tend
to wear with the fingers themselves.


Jarrid Gross


-----Original Message-----
From: owner-alpines@autox.team.net
[mailto:owner-alpines@autox.team.net]On Behalf Of
Jay_Laifman@countrywide.com
Sent: Tuesday, August 26, 2003 8:07 AM
To: alpines@autox.team.net
Subject: Replacing Rocker Arms


I have a clicking rocker arm.  I believe it is because the tip has worn to 
a point that I cannot adjust the gap right anymore.  I am thinking about 
buying new rockers and wanted to hear if anyone knows anything about what 
is on the market.  In the past, I have heard of replacement parts out 
there being not so good, or had flaws when built, or that it's better to 
get the stock parts rebuilt/reground/hardened, etc., or find NOS rather 
than later, or visa versa.  Anyone know anything about the rocker arms in 
particular?

That also raises a question about the replacement in the first place.  As 
far as I can tell, only one is clicking.  I have run the engine with the 
valve cover off, sliding in a feeler gauge on each rocker.  This is a very 
neat thing - and certainly how they did valve adjustments for older cars - 
and older cars still had the rockers out in the open.  Anyway, only one 
seemed to be making the noise and only that one got better when sliding in 
the gauge.  That said, I figure if one is going, the others are probably 
just as close.  But, I'm not in a rush to spend all that money.  Also, I 
don't know how often the shaft itself wears out and needs to be replaced. 
Any comments on any of this would be appreciated.

Thanks,

Jay

P.S.  I also tried to post this to the SAOC Bulletin Board with no 
success.  I don't know if it is my computer or the web site.  I'll try 
again later.

<Prev in Thread] Current Thread [Next in Thread>