Re: Bellhousing alignment bolt

[John Slade <edalsj@igs.net>]

Following applies to S III and later. I can only assume the same
arrangement is used on S II. On the rear end of the block, the second
hole up on the left should contain a dowel pin, sticking out the back a
half inch or so with a slightly tapered end. In the second hole up on
the right, there should be a dowel bolt, bolt head at the front,
sticking out the back with almost 1/2" of dowel surface, then about 1"
of thread.

John Slade
Manotick, ON