Re: Zenith rebuild source

["jumpin'jan" <servaij@cris.com>]

Scott,
        I have repaired the throttle shaft bearings before. I did it on a
Bridgeport mill and turned the bearing material on a small lathe. It
worked great. Another suggestion is to find the original replacement
float needle and seats, because the Gross-jets are too unreliable
because of it's design. 
Jan
-- 
   ______  ______  _______
  / ____/ / ____/ / ___  / 
 / /___  / /___  / /__/ /   _|  _   _  .  _   _   _
/___  / /___  / / __  _/   (_|_(/_ /_)_|_(_|_| )_/_)
___/ / ____/ / / /  \ \                   _|
____/ /_____/ /_/    \_\http://www.ssrdesigns.com