| To: | alpines@autox.team.net |
|---|---|
| Subject: | Intake manifold. |
| From: | william.lewis@ucdmc.ucdavis.edu |
| Date: | Mon, 14 Aug 2000 14:54:29 -0700 |
Does anyone have any thoughts on the relative merits of a single 45DCOE
weber versus the dual sidedraught webers? My reworked 1725 is running a
little lean as it smooths out at speed with the choke out a little. I have
the bigger jets for the twin Zeniths, so I will reinstall those. But in
the long run, I was thinking about hunting down a little more high
performance carb set up.
Bill Lewis
FrankenSeries II
"jumpin'jan"
<servaij@cris.com> To: maxim
<maxim@post7.tele.dk>
Sent by: cc: alpines
<alpines@autox.team.net>
owner-alpines@auto Subject: Re: Inlet manifold.
x.team.net
08/10/00 10:23 PM
Please respond to
"jumpin'jan"
Chris,
If you are going to pay a shop to make a manifold, I would have
them
make one designed around a single 45DCOE weber carb. I have bought a
manifold from Tom Wiencek a little while ago, but I haven't the time to
install it yet.
Jan
--
______ ______ _______
/ ____/ / ____/ / ___ /
/ /___ / /___ / /__/ / _| _ _ . _ _ _
/___ / /___ / / __ _/ (_|_(/_ /_)_|_(_|_| )_/_)
___/ / ____/ / / / \ \ _|
____/ /_____/ /_/ \_\http://mall.turnpike.net/~servaijm
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Theodoli Harrington, Steven Silverstein |
|---|---|
| Next by Date: | A few thoughts, Pasanville |
| Previous by Thread: | Theodoli Harrington, Steven Silverstein |
| Next by Thread: | A few thoughts, Pasanville |
| Indexes: | [Date] [Thread] [Top] [All Lists] |