6pack
[Top] [All Lists]

Re: [6pack] Upgrading Nuts - Stainless vs Grade 5

To: "Corey Sherman" <cm.sherman@verizon.net>, <6pack@autox.team.net>
Subject: Re: [6pack] Upgrading Nuts - Stainless vs Grade 5
From: "Greg Dito" <dito9561@bellsouth.net>
Date: Sat, 31 May 2008 15:37:01 -0400
Corey,

When I rebuilt my chassis and suspension I replaced just about every nut, 
bolt and washer with Grade 8 hardware from the local Fastenal supplier 
(NFI).  You can purchase exactly what you need at a lower unit cost than 
most other places, including your local hardware store.  But frankly, you 
should not buy hardware from there anyway as the quality is not up to the 
standard that a specialized fastener distributor can provide.

Zinc is intended to become the oxidized surface over time, kind of the 
sacrificial lamb, thus protecting the the steel from the same fate.  If you 
want to prevent the zinc from oxidizing then the only avenue I know of is to 
spray a few coats of clear enamel over the exposed parts using a piece of 
plastic from 1 litre soda bottles with a hole cut to size to act as a mask. 
A pain in the tail but it works great.

I would never use stainless steel on anything subject to high stress (i.e. 
engine and suspension).  Maybe overkill but stainless will also eventually 
oxidize so the tradeoff is not worth it in my opinion.

Greg Dito
CD6250L

----- Original Message ----- 
From: "Corey Sherman" <cm.sherman@verizon.net>
... Has anyone used Stainless Steel 18-8? Or should I stick with Zinc Grade 
5 (TRF stock) or consider Steel Grade 8.
>
> Please share your 6-opinions, experience and advice.
> Corey
> _______________________________________________
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>