6pack
[Top] [All Lists]

Re: [6pack] Re: [TR] Removing TR6 body from frame

To: Alan Salvatore <6parts@charter.net>
Subject: Re: [6pack] Re: [TR] Removing TR6 body from frame
From: Robert Lang <lang@isis.mit.edu>
Date: Tue, 6 Nov 2007 10:55:05 -0500 (EST)
On Mon, 5 Nov 2007, Alan Salvatore wrote:

> Seems the prefered way is to remove the doors.
>
> I don't need to do any paint work in that area.
> Is there a way to brace the door area without welding ?

You can bolt a piece of angle from the dash support hole on the A post (a 
single 1/4-28 bolt) to the convert. top mount holes on the B post.

I use 2" angle that's thick - 3/16" min. The 1/8" angle isn't stiff 
enough.

I also like to bolt in a piece from the upper seat belt mount on the wheel 
arches.

Doing both makes the tub pretty stiff.

If you're paranoid, then bolt some angle across the two side angles (side 
to side) and think about at least one diagonal brace so the think can't 
twist.

> Al Salvatore

regards,
rml
---------------------------------------------------------------------------
Bob Lang              Room N42-140Q            |  This space for rent
Consultant            MIT IS&T unix-linux-help |
Voice:617-253-7438    FAX: 617-258-9535        |  Cell: 339-927-4489
---------------------------------------------------------------------------




<Prev in Thread] Current Thread [Next in Thread>