6pack
[Top] [All Lists]

Re: Brake Light Switch

To: 6pack@autox.team.net
Subject: Re: Brake Light Switch
From: tr6taylor@webtv.net (Sally or Dick Taylor)
Date: Sun, 16 Oct 2005 23:54:13 -0700
Steve---This subject comes up every now and then. Remember that the
brake light switch is normally open, as when tested at rest on the work
bench. The movement of the plunger should close the switch, as when the
brake pedal is depressed. If your bench test doesn't show this
continuity, the switch could be bad. 
If bad, it could probably be fixed. Then again, they are so inexpensive,
it's hardly worth it.
And yes... If it "works" as designed, there should be enough adjustment
in the threads of the switch to get it up near the pedal, and have it
operating only when the pedal is depressed slightly. 
The pedal moves  away  from the switch when braking, and closes it.

Dick
'73

From: scates@grandecom.net(Steve Cates)   

I have been troubleshooting dysfunctional brake lights on '75 TR6. If I
bypass the brake light switch I have good illumination. I removed the
switch to check it's function. The switch (plunger) moves about 3/8
inch. The circuit does not close until the plunger has traveled 5/16
inch. Because the plunger must travel so far to enable the lights to
work, they never do. 
When I read Dan Masters' troubleshooting, it seems the slightest pedal
movement should cause the lights to function. 
Have I made the correct assumption? If yes, is it possible to fix the
switch or is it best to replace it? 
Steve
Corpus Christ, TX 




<Prev in Thread] Current Thread [Next in Thread>