On Fri, 4 Jun 2004, James Henningsen wrote:
> Hi Bob:
Hi,
> My friend desires to polish and port the head for a high performance
> (street) motor. I have been informed from reputable sources that the Circle
> B head is the best head for this purpose due to the stronger/thicker
> casting.
Copy that - My point is that unless you are totally hogging out the head
and going to HUGE valves and/or milling the head to get combustion
chambers less than 40 cc's, then getting a Circle B head is overkill.
> James
Regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
|