| To: | dmallin@attglobal.net, 6pack@autox.team.net |
|---|---|
| Subject: | Re: TR250 brake MC disassembly |
| From: | Acekraut11@aol.com |
| Date: | Mon, 09 Jun 2003 07:55:26 -0400 |
Don, I went to the local NAPA store, told them that I needed the hex wrench, they ordered it and it came in the next day. I am sure most autoparts stores would do the same for you. I think it was a little over $5. With the wrench and a little force, it came right out. I dont believe there is any secret to it, just a tight fit. Good Luck, Aaron Cropley 71 TR6 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | A gentle reminder, jonmac |
|---|---|
| Next by Date: | Seeking fuel line Compression 1/4 sleeve, cm.sherman |
| Previous by Thread: | TR250 brake MC disassembly, Don Malling |
| Next by Thread: | Re: TR250 brake MC disassembly, William Maslin |
| Indexes: | [Date] [Thread] [Top] [All Lists] |