Hi Steve,
To get the bump stops I've always used a very large set of vice grips or an
oversized set of pliers (I mean BIG). The only trick is the careful
placement of the vice grips on the bottom-most part of the bump-stop, which
is metal and rigidly attached to the stud. They use standard threads, so
turn in the direction that you are accustomed to. I just did one last
night. If the car is together you can only turn about 1/8 turn at most, so
it takes a while (patience) but I've not been able to get on off that way.
If you don't have a big enough set of vice grips you have to go buy one
because a set of vice grips that are too small will only frustrate the hell
out of you. And on tip: be extra careful when removing the one on the swing
arm, as you can easily tear up the soft alloy of the swing arm if the vice
grips are too low .
Good luck,
Dave
1969 TR6 and nothing else
_________________________________________________________________
Add photos to your messages with MSN 8. Get 2 months FREE*.
|