BELL CRANK

["Don" <cdon2013@earthlink.net>]

Looking for a bell crank  with center bearing for a weber or any good pull
down linkage setup.
Currently have the t6 billet linkage with stainless cross shaft & adjustable
forged rod ends that .. Racecep / Webers in Cal. sells, but now need to
complete this top grade linkage with a bell with center bearing.
R. Mains or D. Wingett , if ether of you guys are out there and listening
feel free to write or ring direct.....collect of course.
DON .. Minnesota Triumphs