Or ... you can buy a new one from these guys ... http://www.gaugeguys.com/Smiths/classic.htm For $135 ... I have no idea what Nisonger charges ... Shelby long around thought <2018540988.841439.132685
The whole thing turns....capilary, bulb, and nut. I can't get the bulb to separate from the nut.....stuck tighter than white on rice. :-) The gauge works and I've only turned it about 30 to 40 degree
I had written to the list a few months ago. After replacement of the clutch master cylinder on my 1972 Triumph TR6, after being correctly bled, with the bar in the central hole as documented, the gea
plan is to remove the existing bar, >measure it, and adjust the new one to that length. Then, after installation into the middle hole, use the screw Craig - BTDT. I did exactly what you suggested abo
Sent from my LG phone ** triumphs@autox.team.net ** Donate: http://www.team.net/donate.html Archive: http://www.team.net/archive Forums: http://www.team.net/forums
Well, it took 1100 miles, but the car experienced its first breakdown while driving, just 1.5 hours ago. I took it to the office, and it ran terrific. Went to head to my second stop, and it would no
The charging system may have been damaged and your battery is low. Phil Ethier West Side Saint Paul Minnesota USA 1973 Triumph Stag LE22439UBW "uncle jack", Sapphire Blue 2004 Suburban 8.1, Sport Red
Good morning all. What kind of spring compressor do y'all use when disassembling Spitfire/GT6 front springs? Thanks to all. ** triumphs@autox.team.net ** Donate: http://www.team.net/donate.html Archi
I see TriumphsOnly's inventory for sale on Ebay again. http://www.ebay.com/itm/Triumph-30-yr-Parts-collection-TR2-TR3-TR4-TR6-TR7-TR8-Stag-GT6-Spit-/160719442979?pt=Motors_Car_Truck_Parts_Accessories
Hello List Friends I'm working on a TR3A for a fellow and I need to get the temp gauge out. Do you have to extend the capilary tube and rotate the entire assembly to get the bulb unscrewed from the e
The fitting that holds the bulb in place is independent, sounds like it is just a little stuck. Maybe some PBB and a gentle nudge? B Hello List Friends I'm working on a TR3A for a fellow and I need t
What he said. The metal part with the hex flats is a nut that should unscrew without rotating the bulb. In fact, usually the hard part is getting the bulb out after the nut has been unscrewed. Next
The fitting turns fine, but the capilary turns too. Aren't they supposed to turn independently? I've been soaking the thing with PB Blaster and Kroil alternately for about a month. I think I'm just g
Does the gauge work? By 'turning too' do you mean if you start to turn the nut - the tube turns as well - AND YOU STOP or, it turns more than just a nudge.... if the latter - the tube has probably se
meant to add - if you take the housing off you can see if the bulb is turning as well. That would mean the tub has broken somewhere in the line. Both cases mean a rebuild is in order. Does the gauge
The whole thing turns....capilary, bulb, and nut. I can't get the bulb to separate from the nut.....stuck tighter than white on rice. :-) The gauge works and I've only turned it about 30 to 40 degree