Search String: Display: Description: Sort:

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Shop\-talk\]\s+GM\s+rear\s+axle\s+C\-clip\s+removal\s*$/: 4 ]

Total 4 documents matching your query.

1. [Shop-talk] GM rear axle C-clip removal (score: 1)
Author: "Randall" <TR3driver@ca.rr.com>
Date: Sat, 11 May 2013 18:36:08 -0700
Ok, I'm stuck. Got a big GM limited slip solid axle with the half shafts located by those stupid C-clips. I've got the locating bolt and the cross pin out. But I cannot get the shaft to move, to get
/html/shop-talk/2013-05/msg00052.html (8,906 bytes)

2. Re: [Shop-talk] GM rear axle C-clip removal (score: 1)
Author: "Randall" <TR3driver@ca.rr.com>
Date: Sat, 11 May 2013 19:09:54 -0700
In the infamous words of Emily Litella, "Never mind!" Turns out, the LSD clutches were slightly out of place (probably caused by yours truly initially trying to remove them) and blocking the motion o
/html/shop-talk/2013-05/msg00053.html (8,432 bytes)

3. Re: [Shop-talk] GM rear axle C-clip removal (score: 1)
Author: Dave C <cavanadd@frontier.com>
Date: Sun, 12 May 2013 12:16:30 -0700
Sometimes you can weld a bead along the inside of the race and when it shrinks it'll shrink the race a little, enough to get it out. Or you can weld a piece of steel across the race and use that to g
/html/shop-talk/2013-05/msg00054.html (9,979 bytes)

4. Re: [Shop-talk] GM rear axle C-clip removal (score: 1)
Author: "Randall" <TR3driver@ca.rr.com>
Date: Sun, 12 May 2013 15:45:33 -0700
Thanks for the suggestions. My problem wasn't so much grabbing the race, as persuading it to move afterwards. The failing bearing evidently got hot enough to spot-weld the race to the housing. But a
/html/shop-talk/2013-05/msg00055.html (8,662 bytes)

Current List: 1 - 4
Page: [1]
This search system is powered by Namazu