- 1. the welding thread (again!) (score: 1)
- Author: Unknown
- Date: Thu, 03 May 2001 16:12:32 -0400
- Somewhere, some time ago, someone posted a message that led me to believe it's not hard to adapt your typical 115V hobbyist MIG machine to handle spot welding. Is there any truth to this? -- Douglas
- /html/triumphs/2001-05/msg00125.html (6,804 bytes)
- 2. Re: the welding thread (again!) (score: 1)
- Author: Unknown
- Date: Fri, 4 May 2001 18:29:37 -0400
- "Stick" welders, rather than MIG welders, are the power source for what you're talking about. Eastwoods sells both the welding equipment itself (which I understand is tricky to use) and the attachmen
- /html/triumphs/2001-05/msg00195.html (7,869 bytes)
- 3. Re: the welding thread (again!) (score: 1)
- Author: Unknown
- Date: Fri, 4 May 2001 22:36:53 -0500
- Douglas Frank wrote... Miller makes a small all-in-one spot welder - just plug it in. Several sizes and lengths of tongs available to fit most of what you'd need. Eastwood sells it, but you should be
- /html/triumphs/2001-05/msg00199.html (7,891 bytes)
- 4. Re: the welding thread (again!) (score: 1)
- Author: Unknown
- Date: Sat, 05 May 2001 00:02:54 -0700
- So, what's the essential difference between a stick power source and a MIG power source (other than the stick usually being higher power) ? The attachment that Eastwood sells just says "power source
- /html/triumphs/2001-05/msg00203.html (7,245 bytes)
This search system is powered by
Namazu