- 1. hub grease cup removal (score: 1)
- Author: "R. Cobb" <rcobb@earthlink.net>
- Date: Wed, 12 May 2004 16:56:01 -0500
- I'm trying to remove the left front hub/disc assembly on my BJ8, Phase 2. The stud on the grease cup is bent at an angle (with respect to the interior of the hub cylinder) and the cup itself has been
- /html/healeys/2004-05/msg00325.html (7,192 bytes)
- 2. Re: hub grease cup removal (score: 1)
- Author: Alan Schultz <alan@andysnet.net>
- Date: Wed, 12 May 2004 21:10:03 -0500
- Would a long nose vise-grip be long enough to reach the stud? I think the nose is about 6 inches long. Alan S 67BJ8
- /html/healeys/2004-05/msg00337.html (7,451 bytes)
- 3. RE: hub grease cup removal (score: 1)
- Author: "Vink, Graham" <vinkg@fleishman.com>
- Date: Wed, 12 May 2004 21:59:16 -0500
- not sure if this will work on Healeys, since I can't immediately visualize the cap. But on Triumphs (which don't even have a stud), it's been suggested to drill a small hole in the cap, screw in a he
- /html/healeys/2004-05/msg00340.html (7,776 bytes)
- 4. Re: hub grease cup removal (score: 1)
- Author: "Scott Willis" <ahpowered@hotmail.com>
- Date: Wed, 12 May 2004 23:32:28 -0500
- Not sure if the BJ8 is like the my BN7...if so I just put 2 nuts to lock on the stud that sticks out of the cup. I then pulled in twist motion on the nuts with pliers. Worked for me. you can spray so
- /html/healeys/2004-05/msg00344.html (7,927 bytes)
- 5. Re: hub grease cup removal (score: 1)
- Author: "Greg Lemon" <glemon@neb.rr.com>
- Date: Thu, 13 May 2004 03:11:44 -0500
- I would try a long screwdriver or pry bar, place the tip against the base of the stud and the outer edge of the hub as the fulcrum point and try to push the stud so it is straight enough to get a thr
- /html/healeys/2004-05/msg00350.html (8,794 bytes)
- 6. Re: hub grease cup removal (score: 1)
- Author: Tracy Drummond <bighealey@charter.net>
- Date: Thu, 13 May 2004 04:02:29 -0700
- R. Cobb, Randy? Richard? Raymond? Ha - Rusty? Restorer? Ruthless bolt remover? (I know I am a bit twisted this early in the morning) I just use a 1 or 2 inch long bolt of the same size and thread as
- /html/healeys/2004-05/msg00353.html (9,019 bytes)
- 7. Re: hub grease cup removal (score: 1)
- Author: tld6008@mchsi.com
- Date: Fri, 14 May 2004 13:53:24 +0000
- Rig up the needle nose vice grip to a slide hammer and it should come out easily with several taps. -- Tim Davis BN7
- /html/healeys/2004-05/msg00387.html (7,665 bytes)
This search system is powered by
Namazu