- 1. grease fitting for waterpump (score: 1)
- Author: Unknown
- Date: Fri, 31 Dec 2004 00:52:55 -0500
- While inspecting my waterpump I found something I don't understand. (I can better describe it if you look at the photograph at: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=3420
- /html/triumphs/2004-12/msg00731.html (6,916 bytes)
- 2. RE: grease fitting for waterpump (score: 1)
- Author: Unknown
- Date: Fri, 31 Dec 2004 05:48:23 -0800
- The grease fitting is only for "show", it's not actually functional. The modern bearings are "permanently lubricated". Original pump housings were drilled differently, the grease didn't go through t
- /html/triumphs/2004-12/msg00733.html (6,921 bytes)
- 3. re: grease fitting for waterpump (score: 1)
- Author: Unknown
- Date: Fri, 31 Dec 2004 15:44:50 EST
- The way an OE TR waterpump is 'drilled for grease relief' is a little confusing. Since you can't make angled turns with a straight drill bit, the grease relief path is made by drilling 2 paths that
- /html/triumphs/2004-12/msg00744.html (7,603 bytes)
- 4. grease fitting for waterpump (score: 1)
- Author: "Paul Dorsey" <dorpaul@negia.net>
- Date: Fri, 31 Dec 2004 00:52:55 -0500
- While inspecting my waterpump I found something I don't understand. (I can better describe it if you look at the photograph at: http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=3420
- /html/triumphs/2004-12/msg01493.html (7,512 bytes)
- 5. RE: grease fitting for waterpump (score: 1)
- Author: "Randall" <tr3driver@comcast.net>
- Date: Fri, 31 Dec 2004 05:48:23 -0800
- The grease fitting is only for "show", it's not actually functional. The modern bearings are "permanently lubricated". Original pump housings were drilled differently, the grease didn't go through t
- /html/triumphs/2004-12/msg01495.html (7,517 bytes)
- 6. re: grease fitting for waterpump (score: 1)
- Author: CarlSereda@aol.com
- Date: Fri, 31 Dec 2004 15:44:50 EST
- The way an OE TR waterpump is 'drilled for grease relief' is a little confusing. Since you can't make angled turns with a straight drill bit, the grease relief path is made by drilling 2 paths that
- /html/triumphs/2004-12/msg01506.html (8,119 bytes)
This search system is powered by
Namazu