- 1. Welders (score: 1)
- Author: "Robert Morrow" <bmorrow@horizon-health.org>
- Date: Mon, 15 Nov 1999 15:02:31 -0500
- Good afternoon; Seeing as I am in no way a professional in the auto restoration business, I need your assistance. I will be cutting and welding floor boards and quarter panels, what type of welder do
- /html/datsun-roadsters/1999-11/msg00264.html (6,960 bytes)
- 2. Re: Welders (score: 1)
- Author: Don Miller <turbospl311@yahoo.com>
- Date: Mon, 15 Nov 1999 13:01:48 -0800 (PST)
- wire feed and practice. I bought some flat sheets of metal and practiced welding them together. It took about 3-4 hours to get it right. Also, Depending on your budget, try and get a fully adjustable
- /html/datsun-roadsters/1999-11/msg00267.html (7,614 bytes)
- 3. Re: Welders (score: 1)
- Author: David Urschel <durschel@sprynet.com>
- Date: Mon, 15 Nov 1999 16:34:00 -0500
- I have the same Lincoln setup described by Don. Highly recommended. Don't buy a cheap MIG welder, you won't get good results on thin automotive sheet metal. (I ended up sending one back as it would
- /html/datsun-roadsters/1999-11/msg00268.html (8,332 bytes)
- 4. Re: Welders (score: 1)
- Author: Toby B <toby@wolfenet.com>
- Date: Wed, 17 Nov 1999 09:51:34 -0800
- I'd agree, and have a Century 105 that also does pretty well. It was inexpensive, but works as well as the Hobart... Toby
- /html/datsun-roadsters/1999-11/msg00370.html (7,213 bytes)
- 5. Re: Welders (score: 1)
- Author: "Mike Kerr" <mikekerr@innercite.com>
- Date: Mon, 22 Nov 1999 13:36:14 -0800
- torch wielding works the best on sheet metal but takes a lot more practice than the mig, if it is a no showing area the mig is fine but if it is a surface wield then the torch is better . tig wieldin
- /html/datsun-roadsters/1999-11/msg00509.html (8,143 bytes)
This search system is powered by
Namazu