Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Sealing\s+steering\s+box\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Sealing\s+steering\s+box\s*$/: 4 ]

Total 4 documents matching your query.

1. Sealing steering box (score: 1): Author: "Ron Fine" <RonFineEsq@earthlink.net>; Date: Sat, 12 Feb 2005 18:06:40 -0800; I'm trying to stop a leak from the front plate on my steering box. It is not from the stator tube but around the bolts or shims under the front plate. My shims are correct and new and I had one thin; /html/healeys/2005-02/msg00371.html (7,158 bytes)
2. Re: Sealing steering box (score: 1): Author: "Bob Spidell" <bspidell@comcast.net>; Date: Sat, 12 Feb 2005 18:55:10 -0800; These don't seem to leak that often (hasn't been mentioned on the List, anyway). I'd try to figure out why it's leaking before I'd stack gaskets or add goop. Is the front plate warped, or even crack; /html/healeys/2005-02/msg00373.html (7,882 bytes)
3. Re: Sealing steering box (score: 1): Author: "KENNETH MASON" <meditionm@msn.com>; Date: Sun, 13 Feb 2005 17:42:12 -0800; You might also take a look at the upper-right had bolt as a leak source. The other three bolts are in blind threaded holes and are not wet while the remaining bolt is not blind and is wet all the ti; /html/healeys/2005-02/msg00388.html (7,860 bytes)
4. Sealing Steering Box (score: 1): Author: "Sam Marble" <samncyna@comcast.net>; Date: Mon, 14 Feb 2005 18:52:54 -0500; I had a similar problem and the advice I got was to take the end plate off, clean all the shims carefully and then spray each of them with Permatex aerosol copper gasket seal on both sides. Then rea; /html/healeys/2005-02/msg00409.html (6,748 bytes)

Current List: 1 - 4
Page: [1]