Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Gas\s+welding\s+Do\'ins\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Gas\s+welding\s+Do\'ins\s*$/: 6 ]

Total 6 documents matching your query.

1. Gas welding Do'ins (score: 1): Author: Sparky <wmtsmith@landracing.com>; Date: Sun, 22 May 2005 9:15:04 -0500; sat. Morning I had a neighbor kid who you can barely get to say anything--he has few words-- had just finished shop 101 Gas Welding come over and give me a 30 minutes of show and tell--mostly show--; /html/land-speed/2005-05/msg00269.html (7,199 bytes)
2. Re: Gas welding Do'ins (score: 1): Author: "Keith Turk" <kturk@ala.net>; Date: Sun, 22 May 2005 10:21:12 -0500; Small torch and low flame.... only that heat which is needed to flow the K; /html/land-speed/2005-05/msg00270.html (6,815 bytes)
3. Re: Gas welding Do'ins (score: 1): Author: LGMCAFEE@aol.com; Date: Sun, 22 May 2005 21:06:00 EDT; One of the problems with a new gas welder is that they use too big a tip and then try to turn it down. What happens then is you will have a lot of torch popping and back fire and burning in the mixin; /html/land-speed/2005-05/msg00275.html (6,960 bytes)
4. Re: Gas welding Do'ins (score: 1): Author: "Ron Gibson" <rgg14@cox.net>; Date: Sun, 22 May 2005 23:23:14 -0500; If your tip is the right size, flame is right heat and fit of material is good you don't need to move the tip much. If your headers are mild steel and you have the time you can just reheat the weld t; /html/land-speed/2005-05/msg00280.html (7,828 bytes)
5. RE: Gas welding Do'ins (score: 1): Author: "Albaugh, Neil" <albaugh_neil@ti.com>; Date: Mon, 23 May 2005 10:53:03 -0500; ....and a neutral flame. Regards, Neil Tucson, AZ Small torch and low flame.... only that heat which is needed to flow the material... K; /html/land-speed/2005-05/msg00290.html (7,233 bytes)
6. RE: Gas welding Do'ins (score: 1): Author: "Albaugh, Neil" <albaugh_neil@ti.com>; Date: Mon, 23 May 2005 10:57:36 -0500; Amen, Larry. Conversely, a too- small tip requires turning up the flow so high that the velocity out of the tip doesn't give a good weld, it tries to blow the weld puddle around. Regards, Neil Tucson; /html/land-speed/2005-05/msg00291.html (7,592 bytes)

Current List: 1 - 6
Page: [1]