Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*EI\s+Distributor\s+Installation\s+Question$s$\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*EI\s+Distributor\s+Installation\s+Question$s$\s*$/: 6 ]

Total 6 documents matching your query.

1. EI Distributor Installation Question(s) (score: 1): Author: "Matthew A. Smith" <matthews517@earthlink.net>; Date: Thu, 7 Sep 2006 19:06:44 -0400; Hi Folks, Here goes: Just so you understand, I'm not trying to slight Gary Boone in any way. I have the utmost respect for what he's done for us Roadster Owners and our cars. I also know that he's go; /html/datsun-roadsters/2006-09/msg00034.html (9,632 bytes)
2. Re: EI Distributor Installation Question(s) (score: 1): Author: "John F Sandhoff" <sandhoff@csus.edu>; Date: Thu, 07 Sep 2006 17:23:31 -0700; I'll cut right to the important part: Yes. -- John John F Sandhoff sandhoff@csus.edu Sacramento, CA; /html/datsun-roadsters/2006-09/msg00035.html (7,459 bytes)
3. RE: EI Distributor Installation Question(s) (score: 1): Author: "andy cost" <andycost@earthlink.net>; Date: Thu, 7 Sep 2006 19:23:59 -0500; The distributor gear is off one tooth. Trust Gary he is right on this one. The gear and drive are held on the shaft with roll pins. There is no way to assemble the drive shaft 20 degrees off. Also, m; /html/datsun-roadsters/2006-09/msg00036.html (11,208 bytes)
4. RE: EI Distributor Installation Question(s) (score: 1): Author: "Graeme" <graemes@internode.on.net>; Date: Fri, 8 Sep 2006 10:14:33 +0930; "Should I try again and throw the 11:25 orientation of that slot on the gear out the window and try rotating that gear till I get the rotor lined up (or nearly lined up) with the contact (such as 1:3; /html/datsun-roadsters/2006-09/msg00037.html (9,423 bytes)
5. RE: EI Distributor Installation Question(s) (score: 1): Author: "Matthew A. Smith" <matthews517@earthlink.net>; Date: Thu, 7 Sep 2006 21:01:15 -0400; Thank you all for the immediate replies, Graeme, Andy, John, Leigh, Pete. Between you guys, I think I have my answer. Plug wires are correct. I did pull the dist stand to alter the position of the ge; /html/datsun-roadsters/2006-09/msg00038.html (7,975 bytes)
6. RE: EI Distributor Installation Question(s) (score: 1): Author: fairladyracing@comcast.net; Date: Fri, 08 Sep 2006 01:49:49 +0000; As was stated earlier, turn the drive gear one tooth. We have always found that the distributer worked best closer to 12/6 than 11/5 on the drive gear. Good luck Dan & Susan; /html/datsun-roadsters/2006-09/msg00039.html (8,449 bytes)

Current List: 1 - 6
Page: [1]