- 1. 1500 Connecting Rod Length? (score: 1)
- Author: "Daryl Smith" <daryl_smith@telus.net>
- Date: Sat, 27 Nov 2004 23:07:28 -0800
- I seem to have come across conflicting info with the 1500 rod at either 144 or 149 mm. Can anyone confirm the actual length of these rods? Thanks Daryl
- /html/datsun-roadsters/2004-11/msg00341.html (7,015 bytes)
- 2. RE: 1500 Connecting Rod Length? (score: 1)
- Author: "Gordon Glasgow" <gsglasgow@comcast.net>
- Date: Sat, 27 Nov 2004 23:31:55 -0800
- The factory manual says 144 mm center-to-center, but that's no guarantee.
- /html/datsun-roadsters/2004-11/msg00344.html (7,650 bytes)
- 3. RE: 1500 Connecting Rod Length? (score: 1)
- Author: "Graeme Suckling" <graemes@saonline.com.au>
- Date: Sun, 28 Nov 2004 18:08:06 +1030
- Daryl, just measured my G1500 rods. As near as I can, they are 144mm centre to centre. Regards, Graeme Suckling 1965 SP310 1971 P510 1972 PL510 1973 HS30 http://www.imagestation.com/album/?id=4290669
- /html/datsun-roadsters/2004-11/msg00345.html (7,678 bytes)
- 4. Re: 1500 Connecting Rod Length? (score: 1)
- Author: "Daryl Smith" <daryl_smith@telus.net>
- Date: Sun, 28 Nov 2004 13:45:03 -0800
- Thankyou Graeme, Gordon and Carl, There are two reasons for my asking: 1. A discussion on the 311s.org site about using the G15 crank in an R16 block to get about 1800cc's. To use a stock R/U piston
- /html/datsun-roadsters/2004-11/msg00350.html (8,355 bytes)
- 5. RE: 1500 Connecting Rod Length? (score: 1)
- Author: "Gordon Glasgow" <gsglasgow@comcast.net>
- Date: Sun, 28 Nov 2004 16:47:26 -0800
- The U20 specs are alredy compiled at http://www.gordon-glasgow.org/U20specs.asp. Not that I see any problem with having this info in more than one place. BTW, the term "deck height" is normally used
- /html/datsun-roadsters/2004-11/msg00353.html (9,930 bytes)
- 6. RE: 1500 Connecting Rod Length? (score: 1)
- Author: "Graeme Suckling" <graemes@saonline.com.au>
- Date: Mon, 29 Nov 2004 20:31:39 +1030
- Hi Daryl, Deck height I can not do, engine is completely dissembled. Piston pin height is 44mm as well as I can measure However, the piston domed, which adds another 3mm to the 44mm. Regards, Graeme
- /html/datsun-roadsters/2004-11/msg00357.html (7,760 bytes)
This search system is powered by
Namazu