- 1. [Spridgets] Engine timing - Mini123 dizzy (score: 1)
- Author: Joe Lansing <kidjoevid@yahoo.com>
- Date: Sun, 8 Jul 2007 10:44:04 -0700 (PDT)
- OK - After checking, I'm pretty sure I was setting static timing with #4 at TDC, not #1. I bumped the engine until I got timing marks to line up again, both valves on #1 closed, and I found the rotor
- /html/spridgets/2007-07/msg00277.html (8,002 bytes)
- 2. Re: [Spridgets] Engine timing - Mini123 dizzy (score: 1)
- Author: Bill L <pythias@pacifier.com>
- Date: Sun, 8 Jul 2007 10:55:43 -0700
- Hello Joe, rather than pulling the dizzy and rotating the shaft, maybe swap #1 and #4 plug wires, and #2 and #3 wires? .. .. get the engine running THEN take care of nice-itys? -- Best regards, Bill
- /html/spridgets/2007-07/msg00278.html (7,322 bytes)
- 3. Re: [Spridgets] Engine timing - Mini123 dizzy (score: 1)
- Author: derf <derf247@gmail.com>
- Date: Sun, 8 Jul 2007 12:47:23 -0600
- I agree with that. I'm not familiar with the 123 dizzies. I imagine the LED comes on for some reason that should be explained in the manual. When you pulled the dizzy, did you pull the dizzy drive sh
- /html/spridgets/2007-07/msg00279.html (7,533 bytes)
- 4. Re: [Spridgets] Engine timing - Mini123 dizzy (score: 1)
- Author: derf <derf247@gmail.com>
- Date: Sun, 8 Jul 2007 12:52:47 -0600
- According to the 123 directions, you should get the green LED with the black wire disconnected. _______________________________________________ Edit your replies http://www.team.net/archive http://au
- /html/spridgets/2007-07/msg00280.html (7,030 bytes)
- 5. Re: [Spridgets] Engine timing - Mini123 dizzy (score: 1)
- Author: "Frenken, Eric" <efrenken@lctax.de>
- Date: Mon, 9 Jul 2007 09:47:47 +0200
- the LED lights through any hole, not one dedicated hole. So check all 4 holes when turning the dizzy. In case the LED won't light anymore and you don't have spark at the spark plugs you must send th
- /html/spridgets/2007-07/msg00330.html (9,035 bytes)
This search system is powered by
Namazu