- 1. "oil" front trunnion (score: 1)
- Author: Unknown
- Date: Thu, 19 Jun 1997 21:32:48 +0000
- Hi all, I have a question, How do you "oil" the front suspention trunnion as the Bentley book says it must be done? When attempting to do this with a grease gun, the oil ends up all over the floor. T
- /html/triumphs/1997-06/msg01263.html (6,838 bytes)
- 2. Re: "oil" front trunnion (score: 1)
- Author: Unknown
- Date: Fri, 20 Jun 1997 11:48:56 +0200
- this was discussed, and solved, a couple of months ago; You just buy a nice little thing from the Mercury Marine company: It's a special "grease" gun intended for high pressure pumping of OIL into g
- /html/triumphs/1997-06/msg01281.html (8,132 bytes)
- 3. Re: "oil" front trunnion (score: 1)
- Author: Unknown
- Date: Fri, 20 Jun 1997 18:00:41 -0400
- I didnt, instead I used to heat the trunnion with a torch to about 200F then pump in grease, which would flow into the grooves at that temp like oil. Hi all, I have a question, How do you "oil" the f
- /html/triumphs/1997-06/msg01329.html (7,153 bytes)
- 4. RE: "oil" front trunnion (score: 1)
- Author: Unknown
- Date: Mon, 23 Jun 1997 12:17:00 -0600
- I have obtained this grease gun but I am confused as to how it is used. The gun consists of a handle like a normal grease gun. In place of the cartridge container into which one would normally load t
- /html/triumphs/1997-06/msg01408.html (8,906 bytes)
- 5. Re: "oil" front trunnion (score: 1)
- Author: Unknown
- Date: Mon, 23 Jun 1997 21:03:38 +0200
- GOOD FOR YOU! You've probably bought the best Marine tool a Triumph Automobile have ever benefited from... ;-) The threaded female connection is intended to take the threaded male nipple on the plas
- /html/triumphs/1997-06/msg01413.html (11,006 bytes)
This search system is powered by
Namazu