A neighbor has a 5o GMC long box std cab with a 228 ci that ran when parked. Has chrome grill , but not frame, and no real rustouts anywhere, but serious surface rust. He is in a pinch for cash, so y
Same wtih my Miq. When I first went into farming I tried raising chicks. Never made any money. couldn't figure out if I was planting them too deep or too close together. Stan oletrucks is devoted to
The light switches that I have removed from my TF trucks are simple. The switch knob and shaft are one unit. reach in under the dash of the truck and on to the top of the light switch. push down on a
I dont believe that there is any IN of OUT specific connection to the heater hoses at the firewall. Stan the man Newberg , or oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
In my 59 sub. I have a completely rebuilt 261. It somehow cracked below the manifolds maybe 5 inches long. Only a trickle, but what gloom and despair. I tried block seal but to no avail. Any experien
I have been driving a 59 suburban, and happened across a guy who sold me a stock radio from his 59 suburban(that he sold earlier) . He said that he paid seventy five bucks for it , and he had a guy r
At the April swapmeet, the breakfast planned would have taken us each too far away from the swap meet at a critical time. Early AM when the bargains are still to be snapped up. So I will take a camps
I have a body guy that swears by a toilet paper moisture trap for automotive spray painting. Right now he is without one and real interested in finding one. Stan the man Newberg Ore oletrucks is devo
I went out the other day and looked at mmy 59 suburban. On the top of the frame, visible by peering over the LF fender is a duplicate of the vin no. on the pillar. Stan the man Newberg Or oletrucks
I found a cool looking hood bird. The numbers are usa56355. Is it for a Thanks Stan the man oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
I found a cool looking hood bird. The numbers are usa56355. Is it for a Thanks Stan the man oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
there is a 58 GMC hood latch on a pickup there is a left side smashed ad sub with the front seats no back doors a 55 or 56 sub with station wagon back doors is that pretty rare? there is a tf panel w
there is a 58 GMC hood latch on a pickup there is a left side smashed ad sub with the front seats no back doors a 55 or 56 sub with station wagon back doors is that pretty rare? there is a tf panel w
I found a 54 or 55 GMC with a virgin windshield, stainless trim on the windshield and door windows, chev engine upside down in the back( casting no indicates 235/261).It has no rust outs in the cab.
does any one know whether a 57 nose from a 1.5 ton will fit a 59 2.5 ton. Did they actually make a 2.5 ton? I found a fellow who has one Thank you Stan the man Newberg, Ore oletrucks is devoted to Ch
If you are going to make your own gasket, I have found this method to yeild the best results. Take a sheet of gasket material and cut it 1/8 inch wider than measured width of the rearend. Tape it to
I hve a neighbor who yanked a running , smoking 235 from an early 50's station wagon. He wants 50 bucks. I live in Newberg Ore Stan oletrucks is devoted to Chevy and GM trucks built between 1941 and
My quest continues. I need to find a set of three rings that are the intake manifold mounting sleeves. When I was a kid I think that they came with the gasket set. Not any more. Anyone got some? Stan
Normally a water pump circulates water through the radiator and back into the block. The normal check is to run the engine with the radiator cap off and let it come up to operating temp. The still w