- 1. U-Joint Replacement (score: 1)
- Author: Unknown
- Date: Wed, 21 Feb 2001 11:36:08 -0800 (PST)
- OK, I'm fighting with the car again... Replacing the u-joints (TR6) seems to be a simple operation, according to the factory manual. Remove the (4) circlips, grasp the axle shaft, then RAP on the yo
- /html/triumphs/2001-02/msg01112.html (6,686 bytes)
- 2. Re: U-Joint Replacement (score: 1)
- Author: Unknown
- Date: Wed, 21 Feb 2001 13:06:28 -0700
- The easiest way that I have found is to use two sockets and a large vise. one socket is slightly smaller in outside diameter than the bearing cup and the other is slightly larger in the inside diame
- /html/triumphs/2001-02/msg01115.html (8,171 bytes)
- 3. U-Joint Replacement (score: 1)
- Author: Unknown
- Date: Wed, 21 Feb 2001 18:33:26 -0500
- Message text written by Fred Marks Replacing the u-joints (TR6) seems to be a simple operation, according to the factory manual. Remove the (4) circlips, grasp the axle shaft, then RAP on the yoke wi
- /html/triumphs/2001-02/msg01125.html (7,069 bytes)
- 4. U-joint replacement (score: 1)
- Author: Unknown
- Date: Tue, 29 Sep 1998 21:45:28 -0400charset="iso-8859-1"
- I have replaced a number of u-joints. Sometime all goes smoothly and sometimes it's a real battle. When I was struggling with the u-joints on my Sports 6' driveshaft I got fed up and took the drives
- /html/triumphs/1998-09/msg01683.html (6,632 bytes)
- 5. U-Joint replacement (score: 1)
- Author: Unknown
- Date: Tue, 10 Jun 97 9:15:08 -0400
- Hey All, I replaced the u-joints in the prop-shoft of the TR6 this weekend. Got the cups in just fine without dislodging any of the needles (except for the cup that feel to the floor, but a nice reco
- /html/triumphs/1997-06/msg00549.html (7,187 bytes)
- 6. Re: U-Joint replacement (score: 1)
- Author: Unknown
- Date: Tue, 10 Jun 1997 13:13:11 -0400
- John, How long ago did you buy the u-joints? They had a problem a while ago where the cir-clips were too thick and if you tried to fit both sides, it would bind the u-joint. Call TRF and speak to Dav
- /html/triumphs/1997-06/msg00630.html (8,300 bytes)
- 7. Re: U-Joint replacement (score: 1)
- Author: Unknown
- Date: Thu, 12 Jun 1997 05:15:25 -0400
- John, when I did mine,a couple of times I could not get the caps all the way on in the vice because one of the rollers fell out into thew bottom of the cap. When I did it right, the thing went togeth
- /html/triumphs/1997-06/msg00719.html (7,698 bytes)
This search system is powered by
Namazu