Mail Archive Search: <+from:nase@ptd.net>

Results:

References: [ +from:nase@ptd.net: 4 ]

Total 4 documents matching your query.

1. Re: steering shaft end play (score: 1): Author: "Phil Nase" <nase@ptd.net>; Date: Sun, 12 Mar 2006 12:53:21 -0500; I have the dreaded steering column play. What shim material is available. I see it as N/A at the usual places. Phil Nase http://home.comcast.net/~philnasecpa; /html/triumphs/2006-03/msg00419.html (7,512 bytes)
2. Re: steering shaft end play (score: 1): Author: "Phil Nase" <nase@ptd.net>; Date: Sun, 12 Mar 2006 13:46:52 -0500; I pulled the pinch bolt out. It looks OK except possibly a little bent. PO had a nyloc nut on it with flat washers. The machined area around the splines is a little worn. I can detect no play in the; /html/triumphs/2006-03/msg00420.html (7,556 bytes)
3. Re: steering shaft end play (score: 1): Author: "Phil Nase" <nase@ptd.net>; Date: Sun, 12 Mar 2006 17:04:33 -0500; Jim's comment made me think again. The splined area has machined groove in it. The 1/4 bolt I used slid right in. Did I get lucky and have it aligned with the groove or doesn't the bolt actually alig; /html/triumphs/2006-03/msg00432.html (7,683 bytes)
4. Re: steering shaft end play (score: 1): Author: "Phil Nase" <nase@ptd.net>; Date: Sun, 12 Mar 2006 19:30:55 -0500; I used a 1/4 x 20 grade 5 with a nyloc nut and loctite. I did buy a 1/4 x 28 and didn't use it cause the one I took out was 20 tpi. I can change it though. If I pin it per Peter C's recommendation sh; /html/triumphs/2006-03/msg00446.html (8,549 bytes)

Current List: 1 - 4
Page: [1]