Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Welding\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Welding\s*$/: 6 ]

Total 6 documents matching your query.

1. Welding (score: 1): Author: "Larry Vaughan" <lvaughan@pldi.net>; Date: Thu, 29 Aug 2002 20:15:08 -0500; Since my body off restore question was answered with a resounding ( two months no way ) I will just repair the cracks and holes, apply my rust neutralizer, spray some touch up paint and use the rest; /html/spitfires/2002-08/msg00451.html (7,743 bytes)
2. RE: Welding (score: 1): Author: "Jon" <triumph@bigolbear.com>; Date: Fri, 30 Aug 2002 08:25:22 -0400; IMHO, the highest setting that lets you "stitch" along without your weld puddle falling through to the floor. Not much help I'm afraid, its like driving a Spitter on a new clutch, suddenly it comes t; /html/spitfires/2002-08/msg00453.html (9,221 bytes)
3. RE: Welding (score: 1): Author: Dan Canaan <flinters@picarefy.com>; Date: Fri, 30 Aug 2002 05:45:28 -0700; Too much current or too long in any one spot and you will burn through the panel. Too low and you stick the surface as the weld cannot heat up the metal fast enough to melt. It's a delicate balance.; /html/spitfires/2002-08/msg00455.html (7,778 bytes)
4. Re: Welding (score: 1): Author: Douglas Frank <frank@zk3.dec.com>; Date: Fri, 30 Aug 2002 10:03:51 -0400; Hi Larry, I don't mean to be flip, but you really should take a course at your local technical college. MIG welding is all about setup, and without a method you're just guessing. But I can say 1/4 in; /html/spitfires/2002-08/msg00461.html (7,852 bytes)
5. Re: Welding (score: 1): Author: "Nolan Penney" <npenney@mde.state.md.us>; Date: Fri, 30 Aug 2002 11:17:35 -0400; Neither work well. Too low an amperage and you never get good penetration, giving you a bead that sits on top of the base metal. Too high an amperage and you blast right through the base metal. To sl; /html/spitfires/2002-08/msg00462.html (9,834 bytes)
6. Re: Welding (score: 1): Author: "Tod Jones" <todjones@rica.net>; Date: Sat, 31 Aug 2002 04:56:24 -0400; Use low amp setting and stitch weld around the piece. it also helps to use a strip of copper behind where you are welding. the copper supports the weld without sticking and acts as a heat sink so you; /html/spitfires/2002-08/msg00474.html (7,215 bytes)

Current List: 1 - 6
Page: [1]