- 1. Spitfire Main Bearings (score: 1)
- Author: "Martin C. Libhart" <mlibhart@feist.com>
- Date: Sat, 27 Mar 1999 13:33:53 -0600
- I finally had time this week to open up the bottom end of my '70 Spitfire motor (1296cc) so I will know what to expect come rebuild time. I've had the motor on an engine stand since starting my frame
- /html/spitfires/1999-03/msg00705.html (7,579 bytes)
- 2. Re: Spitfire Main Bearings (score: 1)
- Author: Joe Curry <spitlist@gte.net>
- Date: Sat, 27 Mar 1999 12:24:40 -0800
- Since the .254mm converts to .010 in., I suspect that the crank has been turned down .010 undersize. This gives credence to your assumption that there has been some lower engine work done previously
- /html/spitfires/1999-03/msg00707.html (8,200 bytes)
- 3. Re: Spitfire Main Bearings (score: 1)
- Author: "james carpenter" <james@jccsystems.swinternet.co.uk>
- Date: Sun, 28 Mar 1999 11:19:27 -0000
- Cylinder head gasket between 1 and 2. Had the same, you need to take the head off, check the level of the cylinder head. If warped get it milled, I suspect it dosent need it. Have a look at your hea
- /html/spitfires/1999-03/msg00717.html (7,773 bytes)
This search system is powered by
Namazu