Search String: Display: Description: Sort:

Results:

References: [ +from:markmiller: 111 ] [ at (Too many documents hit. Ignored) ] [ threeboysfarm.com: 26 ]

Total 20 documents matching your query.

1. [Shop-talk] Power to the garage (score: 181)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 14 Mar 2012 20:59:57 -0700
If you even considered it I would recommend at least burying a > or 1 PVC pipe in there, capped at each end. You can always hook it up (or not) later. _____ Thanks Mark and Phil, I briefly thought ab
/html/shop-talk/2012-03/msg00113.html (8,534 bytes)

2. [Shop-talk] dishwashers (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 26 Jan 2011 20:30:35 -0800
While we're talking about dishwashers (note: we have a pair of Bosch units that work really well, but not with Costco detergent) I highly recommend putting two of them in. If you figure in the lack o
/html/shop-talk/2011-01/msg00425.html (7,950 bytes)

3. [Shop-talk] Phone overload (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sat, 29 Jan 2011 12:44:12 -0800
<<< Thanks for all the advice. The second line may not be an option. I had a second line for dialup but disconnect when I got the cable modem. The first line went bad so the phone company switched to
/html/shop-talk/2011-01/msg00471.html (8,563 bytes)

4. [Shop-talk] Wire gauge: 60 feet at 50A (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Thu, 24 Feb 2011 19:22:48 -0800
<<< I need to run a 50amp circuit about 50 or 60 feet. A calculator on the web says that 55' of 50amp circuit would require 10# wire. Does that sound right? Anyone know what the code states? I'm not
/html/shop-talk/2011-02/msg00207.html (7,887 bytes)

5. [Shop-talk] 50A vs. 30A (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 30 Mar 2011 19:13:29 -0700
<<<I recently purchased a 220v band saw for my shop that has a 30 amp plug. My shop has plenty of 220v outlets, but they are all wired to 50 amp plugs and protected by 50 amp breakers. The 50 amp cir
/html/shop-talk/2011-03/msg00346.html (7,557 bytes)

6. [Shop-talk] Shop-talk Digest, Vol 5, Issue 156 (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sat, 21 May 2011 21:41:48 -0700
<<<In California, by law, up to 10x10 there are no code requirements. Planning folks can stick their nose in if they're going to be above the fence line or otherwise visible, I think, but there's no
/html/shop-talk/2011-05/msg00409.html (7,965 bytes)

7. [Shop-talk] Metric vs inch vs din vs sae vs whitworth vs bsd (sounds like a cage match where everyone loses) (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sun, 29 May 2011 09:41:38 -0700
<<<You really have to pay attention because some of the metric sizes fit pretty well in imperial wrenches. Generally the engine is imperial (I suppose because of it's Buick history), and most of the
/html/shop-talk/2011-05/msg00470.html (8,351 bytes)

8. [Shop-talk] hanging bicycles (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 8 Jun 2011 19:26:43 -0700
<<Message: 9 In order to have more space, I took the wall down between my SHOP and garage space--wish I had done this when we bought the place five years ago!!! The one thing I lost in the process wa
/html/shop-talk/2011-06/msg00427.html (9,713 bytes)

9. [Shop-talk] scooter use (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 15 Jun 2011 21:18:04 -0700
Here is a link to some mobile cupcakes from the Maker Faire based on scooters: http://www.google.com/search?q=cupcake+maker+faire&rls=com.microsoft:en-us:I E-SearchBox&oe=&um=1&ie=UTF-8&tbm=isch&sour
/html/shop-talk/2011-06/msg00465.html (8,167 bytes)

10. [Shop-talk] Stripped carb hole. (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 22 Jun 2011 01:24:27 -0700
<<<Subject: Re: [Shop-talk] stripped screw hole in carb into the material? enough Thanks to all that replied. The consensus seems to be to use the helicoil, or go to the next size up bolt. Unfortunat
/html/shop-talk/2011-06/msg00506.html (8,213 bytes)

11. [Shop-talk] quiet compressor (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 22 Jun 2011 01:27:35 -0700
Hi. I need a compressor for work that will be used in an office/lab type environment. Quiet is what I'm looking for, not a lot of air. I was thinking of getting a small pancake type and sticking it i
/html/shop-talk/2011-06/msg00507.html (8,363 bytes)

12. [Shop-talk] Cat 6 cable (and water) to the garage (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Fri, 8 Jul 2011 20:59:25 -0700
I think you should be able to get the electrician to run an empty flex conduit in the same trench while it is open for the goodwill, as it really isn't any extra work for them. Asking them to place a
/html/shop-talk/2011-07/msg00221.html (9,110 bytes)

13. [Shop-talk] grass pavers (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Mon, 11 Jul 2011 00:08:58 -0700
Some excellent answers already received, and here comes a perhaps lesser one. If it is only a now and again use you can leave it all in grass (following good drainage etc.) and keep some plywood arou
/html/shop-talk/2011-07/msg00255.html (10,351 bytes)

14. [Shop-talk] Quiet air compressor, the recap (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sat, 16 Jul 2011 13:02:29 -0700
I want to thank everyone for their advice as I was snooping for a quiet compressor that we'll use in our lab at work (for anyone who cares: air pressure to drive IC die attach adhesive dispenser, PC
/html/shop-talk/2011-07/msg00266.html (8,628 bytes)

15. [Shop-talk] in ground oil tank (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Tue, 9 Aug 2011 21:45:05 -0700
I agree that any tank should be removed while the liability is someone else's. If you are planning to take it out anyway there is nothing to be gained except the value of the oil, not insignificant b
/html/shop-talk/2011-08/msg00180.html (7,741 bytes)

16. [Shop-talk] 80 cubic foot acetylene bottle? (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sat, 24 Sep 2011 23:34:52 -0700
<< So a local guy has some 200 c.f. oxygen bottles. I'm going to buy them so I don't have to rent them. He's also got an 80 c.f. acetylene bottle he offered me. I'm checking to see if the local place
/html/shop-talk/2011-09/msg00099.html (8,970 bytes)

17. [Shop-talk] Milwaukee vs Dewalt cordless Hex Impact Driver (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Mon, 28 Nov 2011 23:21:46 -0800
I have had some 12 and 14.4V dewalt tools and they were very useable. I had the batteries rebuilt once and by the time they needed a second rebuild they (the batteries) were getting mechanically slop
/html/shop-talk/2011-11/msg00202.html (9,277 bytes)

18. [Shop-talk] Power to the garage (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sat, 10 Mar 2012 15:44:51 -0800
Dot dot dot To: shop-talk <shop-talk at autox.team.net> <CAFnfnRWZQv22hy-A7ODL--GhbuJ-2tx5oJMwJpTJiyJQuX_sQA at mail.gmail.com> Hi gang, I'm planning to run power to the shop (detached garage) and fi
/html/shop-talk/2012-03/msg00097.html (8,025 bytes)

19. [Shop-talk] getting a lift out of a truck. (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Wed, 21 Mar 2012 21:52:00 -0700
<<< Ok gang, I am way short on garage space and I am considering buying a 4-post storage/service lift to ease the congestion. My biggest concern is how to deal with getting the lift shipped to the ho
/html/shop-talk/2012-03/msg00182.html (8,678 bytes)

20. [Shop-talk] Burning cooking oil in your furnace? (score: 171)
Author: markmiller at threeboysfarm.com (Mark Miller)
Date: Sun, 13 May 2012 15:02:19 -0700
<<< I know lots of people burn used cooking oil in diesel vehicles. And since my oil heat is basically diesel fuel, my question is... Can I burn used cooking oil in my home heating oil tank? If so, w
/html/shop-talk/2012-05/msg00047.html (7,858 bytes)


This search system is powered by Namazu