- 1. RE: Hoists (score: 1)
- Author: "Seippel, Jim J" <Jim.Seippel@siemenscom.com>
- Date: Thu, 8 Jan 1998 09:23:03 -0800
- There are several things to consider when you decide what lift you want. You need to look at how far apart the posts are spaced. A lot of the posts are spaced 8 feet apart. This makes it difficult t
- /html/shop-talk/1998-01/msg00016.html (8,106 bytes)
- 2. RE: speed control (score: 1)
- Author: "Seippel, Jim J" <Jim.Seippel@siemenscom.com>
- Date: Thu, 22 Jan 1998 09:10:43 -0800
- FWIW, the DAF Daffodil used 2 belts, one for each rear axle. They used a variable pulley system to control the drive ratio. It was called the "Variomatic". Very smooth and very slow. The DAF had only
- /html/shop-talk/1998-01/msg00081.html (9,785 bytes)
- 3. RE: Bending steel tubing? (score: 1)
- Author: "Seippel, Jim J" <Jim.Seippel@siemenscom.com>
- Date: Thu, 29 Jan 1998 06:31:50 -0800
- If you decide to make a sand bend, it is important to drill a small hole in one of the end plates to allow any steam to escape. When you make the bend, try not to elongate the tubing in the bend. San
- /html/shop-talk/1998-01/msg00113.html (9,051 bytes)
- 4. Cylinder Hone/Glaze Breaker (score: 1)
- Author: "Seippel, Jim J" <Jim.Seippel@siemenscom.com>
- Date: Tue, 16 Dec 1997 17:51:03 -0800
- I am looking for a source for a cylinder hone/glaze breaker. I am looking for the type of glaze breaker that looks like a bottle brush with abrasive stones attached to the end of each "bristle". I ha
- /html/shop-talk/1997-12/msg00053.html (7,376 bytes)
- 5. RE: Cylinder Hone/Glaze Breaker (score: 1)
- Author: "Seippel, Jim J" <Jim.Seippel@siemenscom.com>
- Date: Wed, 17 Dec 1997 14:25:08 -0800
- Thanks to everyone that wrote to let me know where to find a flex-hone. I had asked at least 5 machine shops in Austin where they purchased theirs. All of the suppliers that they referred me to had s
- /html/shop-talk/1997-12/msg00057.html (7,232 bytes)
This search system is powered by
Namazu