- 1. cam bearings clearances (score: 1)
- Author: Scott Cowle <scowle@mentorcollege.edu>
- Date: Thu, 16 Jan 2003 13:03:24 -0700
- Can anyone tell me roughly what clearances should be between a camshaft and the bearings it spins on. On more than one Big Block Mopar engine I 've had problems getting the cam to fit into the block
- /html/land-speed/2003-01/msg00691.html (7,087 bytes)
- 2. Re: cam bearings clearances (score: 1)
- Author: Doug Odom <popms@thegrid.net>
- Date: Thu, 16 Jan 2003 19:57:44 -0800
- Scott, No NO No You fit the bearing to the cam not the cam to the Sometimes you have to scrape the bearing. Most times you can get clearance with a 3 M type pad. The bearing makers say anything from
- /html/land-speed/2003-01/msg00711.html (7,534 bytes)
- 3. Re: cam bearings clearances (score: 1)
- Author: Doug Odom <popms@thegrid.net>
- Date: Fri, 17 Jan 2003 15:19:51 -0800
- Scott, I took a a set of cam bearings off the shelf and measured them myself today. Took a cam out of the box and measured it also. Looked up in the Michigan/Clevite bearing book and the spec's where
- /html/land-speed/2003-01/msg00731.html (8,866 bytes)
This search system is powered by
Namazu