- 1. [Fot] Universal Joint Tool (score: 1)
- Author: "RACER BUD" <budscars@comcast.net>
- Date: Wed, 23 Jun 2010 18:04:46 -0700
- OTC Ball Joint Press It's shaped like a C clamp and is used for u-joint removal without using the adapters. It is about $100 and comes with a series of adapters and carrying case for pushing our pres
- /html/fot/2010-06/msg00164.html (10,828 bytes)
- 2. Re: [Fot] Universal Joint Tool (score: 1)
- Author: GRMTim@aol.com
- Date: Wed, 23 Jun 2010 22:20:20 EDT
- If I remember correctly, I had to make another inlet by drilling another hole and inserting a tube using JB Weld. The original tubes had to be capped. I remember going all over town trying to find c
- /html/fot/2010-06/msg00165.html (6,918 bytes)
- 3. Re: [Fot] Universal Joint Tool (score: 1)
- Author: Scott Janzen <s.janzen@comcast.net>
- Date: Thu, 24 Jun 2010 10:09:52 +0200
- It took me a while to remember this, as I did this so many years ago, but I bought alternate HS6 float bowl covers from Joe Curto. From another, non-TRiumph car, these covers had 2 tubes each, one fo
- /html/fot/2010-06/msg00167.html (6,271 bytes)
- 4. Re: [Fot] Universal Joint Tool (score: 1)
- Author: Tony Drews <tony@tonydrews.com>
- Date: Fri, 25 Jun 2010 00:39:09 -0500
- I checked with my local Napa store and the two kits from OTC would run me 270.00.......Harbor Freight sounds pretty good Mark P -- Original Message -- From: "Bobby Whitehead" <igofaster@att.net> To:
- /html/fot/2010-06/msg00184.html (8,230 bytes)
- 5. Re: [Fot] Universal Joint Tool (score: 1)
- Author: BillDentin@aol.com
- Date: Fri, 25 Jun 2010 08:49:27 EDT
- Just saw some video that were posted on Ted's site (caution wedge Great stuff Ted http://www.tsimportedautomotive.com/racingdays.html Paul _______________________________________________ fot@autox.te
- /html/fot/2010-06/msg00185.html (8,242 bytes)
This search system is powered by
Namazu