I just got my soft top and it *looks* great! BUT, I dont know if there is a specific way to put on all the little metal clips. Is there a specific way? The top did not come with directions... Thanks,
I use an exacto knive to cut the slits/holes for the clips. I usually do it with the top partially installed (snaps to top bow) so I can see where each twistie clip goes. Then push the clip against
I use a white grease pencil or soap to mark the spot for installation of the snaps. Works well for a tonneau and for installing carpeting. Mike it each small at is /// datsun-roadsters@autox.team.net
This may be obvious, but the convex side of the lift-a-dots plates should go away from the body. I did a whole tonneu backward one time and it's a real PITA to correct. Todd -- Original Message -- Fr
Is this like "green side up" when putting in turf? I'm glad that we can laugh at the mistakes done keeping these cars on the road. At least working on seats, tops and radios are safe enough for begi
It was written PAY ATTENTION when installing these tabs! Those that haven't had a top before aren't aware that they pop off FROM ONLY ONE SIDE. (At least, the ones on my Robbins top are that way). Em