I would go with a quality set from one of the vendors, I bought a set from J C Whitney, cheaper and looks it to. if you want I'll sell you mine and order a good set from Dean, CDM, or the others. do
Location Spring fielld Illinois, phone # (217) 525-2975. 67 1600 , Hard top , ratty soft top, runs 37000 miles. owner has had it since 1976, all chrome srraight but has rust, rockers and rear fenders
the small elct motor in the corner of one picture is a constant turning feature, to keep from flat spotting the bearings due to the weight. Russ Southwell 70 1600
Graeme,glad they are finally there. Roadster content I mailed Graeme 2 roadster swirl type horns on 21 Jan 04, they arrived today, so if you mail by slow boat it takes a while. cost $21 for 4lbs from
Just getting warm enough that I can shut of heat in garage so I can empty gas tank to remove, and clean car won't go 3 blocks with out dieingwhile I'm at it i have rebuild kits for the carbs. thanks
the cap on the thermostat tower has no spring(not a pressure relief cap) . you can 1. order one from nissan. 2. orderone from a vendor. 3 order a rebuild kit ( new seal) from a vendor) 4. make your o
Lots of penetrating oil on the sensor, and let it set a few days,its a compression fit, i ended up drilling it out on one eng. will take a look at my spare 1600 tomorrow , but to remove it safely wil
If you have the thermostat tower off you can allso spray penetrating oil onto the back side of the sensor with the plasict tube that comes with most cans. Russ Southwell 70 1600
-- Original Message -- Subject: Re: Swirl type High and Low Roadster horns. Date: Wed, 21 Jan 2004 21:50:19 -0600 From: Russell Southwell <rulee@motion.net> To: Graeme Suckling <graemes@saonline.com.