I believe I recall that the Chevrolet Vega had an oil pressure switch that cut off the electric fuel pump. If I remember correctly, and if any can still be found, they could probably be easily adapte
Is the surface to be channeled hardened? If so, will a milling cutter work? If not, perhaps a groove could be ground (ALA Moto Tool)? Larry /// datsun-roadsters@autox.team.net mailing list
We made a hose size-change adapter by using copper plumbing parts. Not stock, but has worked perfectly well for years. /// datsun-roadsters@autox.team.net mailing list
I disagree that a bad report is not of interest. If we have a bad actor all should have the opportunity to learn about it or at least to carefully consider the circumstances before being hurt themsel
Someday, someone who isn't as careful or knowledgeable as he might be, may attempt to jump start the car, replace the battery or something. Many persons go largely by convention and may assume red is
I use a carbon arc set on an electric welder, put electrodes across the nut, hit the juice, and the nut swells loose immediately. (These also do a good job of brazing without oxyacetylene gas.) /// d
Crocus cloth is fabric backed with a very fine abrasive, like jewelers rouge. A good industrial supply house or hardware store should have it or be able to get it for you. It definitely is not merely
Gas prices. Try this for size. In the mid thirties we had a Fordson tractor. This had two gas tanks and a provision to run hot exhaust through the intake manifold to preheat. Gas was 11 cents and ker
A chain is only as strong as it's weakest link. A series circuit will only carry a load of the lowest fuse. (If put in parallel the ratings are additive.) The series is of value if you have reason to
Two factors to keep in mind: 1. The high cost of carrying slow moving inventory 2. Present inventory must be sold at a sufficiently high price to afford to buy replacement - at ever increasing cost.
Would not the same problem exist with nuts and washers? Maybe everyone should install channel reinforcement? (Also consider reinforcing under the roll bar mounting position.) Larry