You can purchase a sturdy steel drive shaft shroud at any race shop. Good investment and <$50. I've got one on my racer and it just makles good sense! JH Bahn '66 1600 FP Vintage Racer
IUnger will be co-driving Bob Middleton's 510. Gordon Tobias from PA will have his 2000 roadster, though, and I'll have my 1600. All 3 of us will participate in the Marlboro Cup, a 1 hour under 2L en
Why bother with full length? If it's money you're trying to get rid of, the Preparation H, Prozac, Viagra, Rogaine, Automobile City Datsun is always looking for contributions! A 7th place at Summit
I have one on my '66 1600, and it requires a bit of twisting and turning to get the tranny out, at the point where the shift lever bolts in. I've found a high angle on the front of the engine, and tw
Another cheap alternative is the steering wheel off of the early 1980's GM X cars (Citation, Omega, Skylark and whatever the Pontiac was called) sport models (Citation was X11, I believe). The wheel
Scott, Ian: I inadvertantly deleted your email addresses! Email or call me, Re. tomorrow. I can give some directions or we can meet - off Exit 1 from I-83 Stewartstown, or downtown Brogue, about 10:0
Col. Joe Hauser was also a "moderately succesful" roadster racer - 83 SCCA national wins and 3 SCCA national championships - all in a lowly Datsun 1600 G Production! JH Bahn '66 1600 Vintage Racer
This is a multi-part message in MIME format. --part0_919471334_boundary Content-ID: <0_919471334@inet_out.mail.aol.com.1> I've got you all beat for ugly with my '67 411 SSS. Looks like one of those r
Scott & Ian: I have picked up all the stuff from Scott's place in NJ - 3 trips, 1000+ miles in some gawd awful weather(!) and more damn tolls than I care to add up. Everything but one rolling frame/c