- 1. Oil Cooler question (score: 1)
- Author: Bill & Denise Harben <harben@surfbest.net>
- Date: Sat, 08 Jun 2002 14:13:11 -0700
- Hi all, I am trying to route the oil cooler hoses on my Series IV with a Series V engine (if that makes a difference). There doesn't appear to be any holes for mounting the oil cooler. Can someone de
- /html/alpines/2002-06/msg00076.html (7,089 bytes)
- 2. Speedometer Cable Routing (score: 1)
- Author: Bill & Denise Harben <harben@surfbest.net>
- Date: Fri, 24 May 2002 19:40:42 -0700
- Hi all, Can anybody describe the routing of the speedometer cable from the tranny to where ever it enters the passenger compartment? I didn't take the series IV Alpine apart, so I am not sure of the
- /html/alpines/2002-05/msg00201.html (6,401 bytes)
- 3. Drive Shaft Replacement (score: 1)
- Author: Bill & Denise Harben <harben@surfbest.net>
- Date: Thu, 30 May 2002 21:58:45 -0700
- Hi all, I am struggling installing the drive shaft on my Series IV body/Series V engine. It is as if the splines don't quite match the transmission although the shaft does go onto the splines about 1
- /html/alpines/2002-05/msg00294.html (6,718 bytes)
- 4. Thermo Housing (score: 1)
- Author: Bill & Denise Harben <harben@surfbest.net>
- Date: Sat, 16 Mar 2002 14:14:25 -0800
- As I am preparing to bolt the head to the block of my 1745cc Alpine, I noticed there is interference between the thermo housing nut and water pump housing. The head will not fully seat on the block
- /html/alpines/2002-03/msg00159.html (6,661 bytes)
This search system is powered by
Namazu