- 1. A cold day for sixing (score: 1)
- Author: "Mark Creamer" <mcreamer@cinci.rr.com>
- Date: Sat, 18 Nov 2000 20:26:21 -0500
- Hi all, took a little drive early this morning. It's very cold here in Cincy. My heater fan is blowing a fuse, and it happens to be the one that also controls turn signals, gas gauge and temp gauge.
- /html/6pack/2000-11/msg00057.html (7,292 bytes)
- 2. Re: A cold day for sixing (score: 1)
- Author: David Friedlander <forzion@maine.rr.com>
- Date: Sat, 18 Nov 2000 20:57:16 -0500
- Hey Mark; "How are everyone's winter projects going?" I've got a dismantled differential all over the garage floor. Also, replacing seals and rear hub bearings, u-joints. Even welding new trailing ar
- /html/6pack/2000-11/msg00058.html (7,439 bytes)
- 3. RE: A cold day for sixing (score: 1)
- Author: Peter Zaborski <peterz@merak.com>
- Date: Sat, 18 Nov 2000 20:19:18 -0700
- < and later > Not that I have ever done this myself but... Check that when you re-installed the fan switch, you did not bend the lowest tab on the back of it down so that it contacts the dash suppor
- /html/6pack/2000-11/msg00059.html (7,582 bytes)
- 4. Re: A cold day for sixing (score: 1)
- Author: "ROBERT L. GANNON" <trsix74@earthlink.net>
- Date: Sun, 19 Nov 2000 07:24:12 -0500
- I have had my six for over 6 years now and have never been able to figure this one out. I resigned myself to the fact that this was one of the few imperfections on the car that would remain. As for D
- /html/6pack/2000-11/msg00060.html (9,168 bytes)
- 5. RE: A cold day for sixing (score: 1)
- Author: "Gary Moore" <tikasfamily@earthlink.net>
- Date: Sun, 19 Nov 2000 12:38:43 -0500
- Right now I have the interior gutted to get ready to swap in a new tranny with overdrive. While I am doing that I am also replacing the home made dash (which is very nice grant it) with a solid walnu
- /html/6pack/2000-11/msg00061.html (8,242 bytes)
- 6. Re: A cold day for sixing (score: 1)
- Author: Dale Morgan <tpdwinch@yahoo.com>
- Date: Sun, 19 Nov 2000 13:00:05 -0800 (PST)
- Mark Just finished welding in the rocker panel on the passenger side this weekend. Still have to repaint the areas that were ground and welded with POR-15 before moving on. Hope to have the two passe
- /html/6pack/2000-11/msg00062.html (7,854 bytes)
This search system is powered by
Namazu