OK. One more question, Do I need the shim for the middle rocker pedestal?
Buckey
---- Edward Brorein <edbro03@yahoo.com> wrote:
> Hi Buckey,
Â
I am guessing you are referring to a Moss catalog, MGA by chance?
Â
Anyway, there is only on locating screw and lockplate to hold the rocker shaft,
which go on the end rocker assembly pedestal. There is a corresponding hole
drilled in the rocker shaft that the nose of the locating screw goes into. No
lockplates or screws on the other pedestals.
Â
Ed
________________________________
From: "webuck1@cox.net" <webuck1@cox.net>
To: "zmagnette@autox.team.net" <zmagnette@autox.team.net>
Sent: Tuesday, May 27, 2014 1:46 PM
Subject: [Zmagnette] engine rebuild question
OK. I am 99.9% done with my rebuild. Here is my question for you rebuilders:
The head has a screw in part called screw- rocker shaft locating (on pg. 10,
#92 of catalogue spring/summer 2014). The other three push in pieces that look
the same as the screw are missing. Do I :
A) Buy three screws and grind to push fit,
B) just use a washer and nut with no lock plate piece # 91, as above.
What say you.
Buckey in hot AZ.
_______________________________________________
Zmagnette mailing list
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/zmagnette/edbro03@yahoo.com
_______________________________________________
Zmagnette mailing list
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/zmagnette/mharc@autox.team.net
|