Sue,
It broke on the outer flange. I plan to magna-flux two replacements (25
spline) While I have it apart I will check for any play at the bearings and
carrier.
Warm Regards,
Tracy Drummond
PMP | ITIL Service Manager | CISSP | bighealey@charter.net | 408-394-3444
cell | 408-776-0133 home | http://www.linkedin.com/in/tracydrummond
-----Original Message-----
From: vintage-race-bounces@autox.team.net
[mailto:vintage-race-bounces@autox.team.net] On Behalf Of Sue Salsburg
Sent: Saturday, January 09, 2010 7:33 PM
To: vintage-race@autox.team.net
Subject: [Vintage-race] MGA broken axles
Better rear axle bearings(easy cross at a bearing supply house), fine spline
rather than coarse, better rear location( panhard,watts link), correct
torque on hub nut & the final fix is a support to stiffen the housing
itself. We run a welded rear & 6" rims with slicks. Have FINALLY stopped
breaking axles from a standing start in hillclimbs. Where are you breaking
them & when? Sue
You are subscribed as bighealey@charter.net
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Vintage-race@autox.team.net
http://autox.team.net/mailman/listinfo/vintage-race
|