You have the correct Cannon part number for a GT6 manifold, but Pierce's
picture shows a TR6 manifold. The "correct" GT6 manifold is three separate
manifolds, with the front manifold "dropped" to give bonnet clearance. The
pictured manifold is one piece, with all three carbs on the same horizontal
plane. If you used the pictured manifold on your GT6, you would have to cut
a hole in the bonnet. There is a guy who runs a GT6 in VARA, I think his
name is Steve Smith. He runs webers on his GT6 and would be someone to
contact.
-----Original Message-----
From: KLynch7589@aol.com [mailto:KLynch7589@aol.com]
Sent: Sunday, March 23, 2003 3:40 PM
To: tr6nut@sbcglobal.net; vintage-race@autox.team.net
Subject: Re: FW: [Fwd: 1967 Triumph GT6]
Pierce is the one! click on "Triumph", then carb conversion kits. I think
this will
give you a pix of the manifold but the description lists 3X 40 DCOE Weber
Carburetors - Products and Services - Pierce Manifolds, Inc. 99003.820
Kev
Be an organ donor!
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/vintage-race
|