Folks,
I have been looking for two types of wheel nuts for 7/16-20 studs.
The first is the normal American taper seat and the second would be a
straight shoulder shank for mag wheels. I need a long hex surface; about an
inch and a half to two inches and they should be open-ended. (There is
little clearance to the mag wheel spoke-Compmotive reproduced Minilites. We
have a very large bolt hole circle - 4 3/4"). Does anyone know who makes
such an animal? I have seen them on Mustangs, etc.
Thanks,
Chuck Sadek
Yenko Stinger
YS 73
|