You might try Pierce Manifolds at (408) 842-6667. They should have
generic linkage rods that are at least intended for use with Webers.
No telling if they have a TR4 specific setup.
>I recentley acquired a pair of DCOE 40 Webers which were attached to a
>TR4 I bought. They have a very goofy, and not very good, homemade
>linkage setup. I put them on the shelf and put the original Strombergs
>on the car. I would really like to use these carbs though. Does anyone
>have, or know where I can get the throttle linkages for these carbs???
|