I can not get fluid to move from the clutch side of the Lockheed master
cylinder on my TR2. Brake side bled fine. MC was rebuilt by PO. Iâ??ve been
through it twice trying to find the problem. The MC is on the bench,
disassembled again. It was assembled correctly, the pistons depress and
return, all holes/lines are open, rubber is new, fit is snug, cylinders have
been honed, clean Dot 5 fluid, line to clutch slave is clear. Am completely
unable to get any fluid out of the cylinder. The piston does move full travel
when trying to bleed. Any suggestions on how to get the fluid moving will be
most appreciated.
John DeLuca
Sent from my iPad
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|