I don't think the unidirectional (overrun) clutch can slip. It can only
break and you would know it. I'd guess it is just slipping. 350 is about
right for a large accumulator model, but you need about 450 for a small
accumulator. Low pressure is usually just spring fatigue. That can be
fixed by shimming the spring with a couple of hardware store washers.
I'd get the pressure up to spec first before anything else. I suppose
the type of oil might cause slipping too.
?- Larry Young
On 8/1/2018 12:02 PM, Glenn Franco via Fot wrote:
> Looking for some help from the wisdom of the FOT List.
>
> I have rebuilt a number of Triumph A-type overdrive transmissions in
> the last few months but have one that is giving me problems.
>
> The overdrive functions OK when applied and will go into overdrive at
> a steady cruising speed.
>
> The problem is when under load accelerating up a hill or to pick up
> speed it softly drops out. When you lift throttle it will go back in.
>
> We put a 500 psi gauge on the operating valve thinking we were losing
> oil pressure when it drops out of overdrive. Gauge reading shows a
> pretty steady 340 psi reading. When it drops out the gauge doesn't
> drop out but remains steady.
>
> 340 psi is lower than the expected 400 - 500psi. Does that indicate
> oil pump replacement is necessary? The engine rpm was approximately
> 2500-3000 rpm.
>
> Since it softly drops out of overdrive I'm thinking a slipping
> overrunning clutch??
>
> Any advice would be greatly appreciated.
>
> Thanks in advance
>
> Glenn Franco
>
> 74 TR6 , TR250, MG TC, BMW e10 2002
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/fot
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/cartravel at
> pobox.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20180801/9a625675/attachment.html>
|