triumphs
[Top] [All Lists]

[Fot] TR6 transmission rebuild - counter shaft gears

Subject: [Fot] TR6 transmission rebuild - counter shaft gears
From: fubog1 at aol.com (fubog1)
Date: Mon, 8 Jan 2018 09:33:33 -0500
References: <4217F2D0-224C-4534-A59F-147459EEF066@icloud.com>
It probably has the later type shell bearings and 1 or both have worked loose 
in the laygear housing bore and "milled" into the thrust washer (s).
Glen

 

 

 

-----Original Message-----
From: Greg Blake via Fot <fot at autox.team.net>
To: Fot <fot at autox.team.net>
Sent: Sun, Jan 7, 2018 8:56 pm
Subject: [Fot] TR6 transmission rebuild - counter shaft gears

I am rebuilding a TR6 transmission and ran into a strange snag. When I removed 
the countershaft the counter shaft gears did not drop to the bottom of the 
case. I had to tap on the counter shaft gear set with a brass punch to get them 
to move far enough to allow the input shaft and gear to be removed. Now that I 
have the main shaft out of the case, I can't get the counter shaft gears out of 
the case. I've been able to move them a little bit by tapping on the gears with 
a brass punch through the drain hole but I can't get them out. Has anyone run 
into this before?  Any ideas to get them out?

Thanks. 

Greg

Sent from my iPhone
_______________________________________________
fot at autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive



-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180108/6b9e8881/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>