> 2- Is there any other car with similar parts I can use or adapt?
I may have followed the links wrong, but it appears that some Dolomite Sprints
used the same rear brake setup as late GT6. Does
this look right?
http://www.dolomitesprint.com/images/parts_list/pages/02-57.gif
If so, Quiller has the adjusters listed (tho of course that may not mean they
are in stock).
http://www.triumphshop.co.uk/Quiller/PartsCatalogues/Dolomite/Dolomitecatalogue.htm
I didn't found a source for the H-shaped piece (519760), but it doesn't look
too hard to fabricate.
http://www.rimmerbros.co.uk/Item--i-519760
Ordinary mild steel should do fine.
I did find an old post on the Dolomite Club forum where someone said they had
some available a few years back. A long shot, but
might be worth contacting them to see if they could at least supply dimensions.
Or you could even join up and ask again.
http://forum.triumphdolomite.com/viewtopic.php?f=10&t=17688&view=previous
-- Randall
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|
