interesting.. the TR6's will go (as I recall) up to 36 degrees total
advance.. I think I'll just run it up around there and see how it runs...
dave
On 10/2/2014 3:49 PM, ptegler wrote:
> if you pop off the points plate, then pull the little screw in the top
> center you can lift off the top hald of the mech adv weights plate.
> The adv degrees number will be stamped right into the plate.
> remember though that number is on half of the crank adv value so if
> stamped 6 degrees it's 12 at the crank 10 would be 20 at the crank etc.
>
> as general info.... mech adv is usually 20 or less (usually less) a
> the crank
> ptegler
>
>
> On 10/2/2014 5:06 PM, David Porter wrote:
>> Anyone know what the total allowable ignition advance is for these
>> Delco-Remy units?
>> I'm only seeing about 15 degrees at 3000 + RPM Doesn't seem enough
>> to me..
>> Dave
>
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/frogeye@porterscustom.com
>
>
--
Dave Porter Porter Custom Bicycles 2909 Arno St. NE Albuquerque, NM
87107 505-352-1378 Go HERE: my world www.porterbikes.com/
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|