| To: | <triumphs@autox.team.net> |
|---|---|
| Subject: | [TR] TR6 Cylinder Head |
| From: | Jonas Payne <jagmog@hotmail.com> |
| Date: | Thu, 5 Sep 2013 14:17:57 -0700 |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | triumphs@autox.team.net |
| Thread-index: | Ac6qfWRWySE/FlQWQDa+d4Axmwavyw== |
It would appear that I have some bad seals/guides on my recently acquired and running tr6 project. Looks like I'm going to have to pull the head and have some work done. Are there any relatively low cost performance enhancements I should look into while I have it off? 3 angle valve grind? Oversize valves? Slight decking of the head to raise CR? Jonas Payne PBR Consulting 702-882-6711 ** triumphs@autox.team.net ** Archive: http://www.team.net/archive |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TR] TR3 tonneaau revisited, Chris Simo |
|---|---|
| Next by Date: | Re: [TR] TR3 tonneaau revisited, Dave1massey |
| Previous by Thread: | Re: [TR] TR3 tonneau revisited, wbeech |
| Next by Thread: | Re: [TR] TR6 Cylinder Head, glemon |
| Indexes: | [Date] [Thread] [Top] [All Lists] |