On Thu, May 9, 2013 at 8:28 PM, Dave <dave@ranteer.com> wrote:
> ... it leaks quite a bit from the bottom of the sediment bowl at the fuel
> pump so
> obviously I need to get that taken care of. likely just a gasket?
Hopefully a new gasket will stop the leak but sometimes a PO has tightened
that bale a bit too enthusiastically and caused the portion of the casting
that is the top of the bowl to bow a bit making it hard to get a good
seal. The pump is a sort of pot metal and bends rather easily, but when I
have encountered such a bow I have been able to rebend the top back into
nearly flat condition.
Geo
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|